Base for Gas Lift Bar Stool- Bright Chrome Finish 43cm

Free Shipping to Brisbane, Sydney, Canberra, Melbourne, Adelaide & Perth Metro areas

To remove the gas strut follow the link below.

https://www.youtube.com/watch?v=2jzbySSvsrk

Do you have an gas lift stool twith a damaged or rusty base?

Features - 43cm Replacement base for Gas Lift stools with black plastic floor protector.

Please make sure you don't put bases onto wet floors, the protector ring may mark the floor.

Powder coating available as an optional extra, at extra cost, just add a base/s to cart and then also add the powder coating if required.  

Made in China

Dimensions:

Diameter: 430mm; Centre hole 48mm

Suitable to replace for a round chrome or stainless steel base with a 49mm hole and 50mm Gas Strut.

Can be used for residential use

To replace a broken gas strut in your bar stool follow the below steps. or go to https://www.youtube.com/watch?v=2jzbySSvsrk

 To remove the base from the gas strut. Place the base upside down (the seat and gas strut facing the floor) on a hard surface, we use a bench that is the same height as a kitchen bench. We recommend using a 1-3/16 socket bit to help bang the old gas strut out. Place the socket on the gas strut end and hit the socket set with a hammer. If you find that it is hard to get out spray some WD40 into the gap where the strut and the base meet and let it sit for an hour or so and try banging it out again.

Once you have the old gas strut out simply place the gas strut back into the base.

If you have any questions through this process you are more than welcome to contact us on (07) 5479 5502 and we will be more than happy to walk you through step by step to ensure you get it right the first time.